Danfoss - FHM-C1 - Mixing shunt with a low-energy, variable speed pump (Grundfos UPM3).

Mixing Shunts for Floor Heating

The Danfoss compact mixing shunts are used for regulation of flow and supply temperature in hydronic floor heating systems.

The compact, flexible design allows mounting the mixing shunt directly to the manifold on both left and right side, with the primary pipe connection from the side or below.

A self-acting proportional regulator is used to regulate the supply temperature. The regulator ensures that the desired supply temperature to the underfloor heating system always remains constant.

A built-in check valve ensures correct flow direction. An air-vent on top and a thermometer completes the mixing shunt. An optional thermostat protects the floor against too high temperatures.

FHM-C1 is equipped with a low-energy, variable speed pump (Grundfos UPM3 Auto).

The FHM-C1 compact mixing shunt can be mounted directly to the Danfoss manifold system without the use of special equipment.

Should water treatment be used it is essential that dosing instructions of the manufacturer are strictly observed.

Please note that it is recommended that formulations containing mineral oil are avoided.

Customers who bought this also bought

Danfoss Mounting Brackets Set for Manifold FHM-C1

£5.00£6.00

Danfoss Ball Valve for Manifold 1'' with Tail Piece

£23.27£27.92

Danfoss 16mm x 2.0mm ALUPex Pipe Fitting

£3.77£4.52

Danfoss TWA-A NC 230V Thermal Actuator

£12.66£15.19

Underfloor Heating Edge Insulation 50 meter roll

(1 reviews)

£15.87£19.04

Pipe Fixing Clips 60mm (Pack of 300)

(1 reviews)

£11.43£13.72

16mm European Standard Pex-Al-HDPE Pipe 80m

£63.25£75.90

16mm European Standard Pex-Al-HDPE Pipe 90m

£71.14£85.37

16mm European Standard Pex-Al-HDPE Pipe 70m

£55.33£66.40

16mm European Standard Pex-Al-HDPE Pipe 100m

£79.06£94.87