Shopping Cart
Amazing Discounts
| Follow the step by step instructions below to install your Devimat system. | Download Installation Movie |
|
Step 1Measure the room and draw a sketch to help you calculate which DEVI package you will need. Then sketch in the position of the devimat heating cable mat. Choose the correct Devimat and install on the recommended floor construction. |
|
Step 2Mark the positioning of the toilet before you remove it. This helps you avoid placing the toilet on top of the mat - and prevents you from piercing it with screws. |
|
Step 3Cut a channel approx. 10 mm deep and wide in the wall and the floor, from the thermostat and about 1 m out into the floor. Glue the flex pipe for the sensor into this channel, and seal the end of the pipe with a piece of tape. Carry out the first fix installation for the electrical connections. Click here for further information. |
|
Step 4Clean the floor thoroughly, removing all dirt and soap residue, (optional: install Aquapanel Thermal) then lay out the self-adhesive cable mat. The floor surface must be primed if you are not laying the mat on existing tiles. Use Aquapanel Thermal to improve the thermal performance of your underfloor heating system. Click here for more information. |
|
Step 5Clip through the grey netting to turn the mat over - but make sure that you do not cut through the red cable! |
|
Step 6Turn the mat and position it as required. The self-adhesive effect can withstand 10-20 adjustments, so you can move the mat several times until you are satisfied with the result. |
|
Step 7Once you have positioned the cable mat, you can - depending on the new floor surface - encapsulate it using selflevelling screed or cover it with a thin layer of tile adhesive. |
Fix tiles using correct adhesive. Click here to see our Recommended Installation and Adhesive Preparation Guide. Check with the tile manufacturer and the adhesive supplier regarding the most suitable adhesive for you particular project.